
UNITED CHEMICAL · TECNOLOGIA DI PRODOTTO · 20 NOVEMBRE 2026
Un non-cianuro route is only as good as its control logic
Operations evaluate a leaching agent on peak recovery and stop there. In practice the operating cost is set by three variables that move together.
Operations evaluate a gold leaching agent on peak recovery and stop there. In practice the operating cost is set by pH, reagent dosage and solution chemistry moving together. AuLeach™ Agente di lisciviazione dell'oro (GDA) – Non pericoloso ships as a common chemical and is used in Lisciviazione del cumulo and Lisciviazione in vasca circuits where permissible cyanide use is constrained or permitting is difficult. This guide shows how to tune it without rebuilding the plant.
1. Where the non-cyanide route fits
Three situations favour a non-cyanide lixiviant: jurisdictions where cyanide permitting is constrained; sites located far from licensed cyanide supply chains; and ores where cyanide consumption is uneconomic because of base-metal demand. In each case the decision should be made on test work, not on assumption. The comparison is straightforward: run the same ore through a conventional Carbonio in lisciviazione bottle roll and a GDA bottle roll, then compare extraction, consumption and solution chemistry.
For projects where cyanide remains the preferred route, AuCyan™ Cianuro di sodio NaCN (≥98.3%) remains the reference reagent. The two routes are complementary, not competing, and a technical team should be able to model both.
2. Bottle-roll test design
Start with the ore, not the reagent. Characterise each ore domain separately. A typical programme uses 1 kg of pulverised ore at 40% solids, with three dosage levels and a control, sampled at 2, 6, 12 and 24 hours. Record gold extraction, reagent consumption and pH drift at every point. The shape of the extraction curve tells you whether the circuit is reagent-limited or kinetics-limited.
| Variabile di prova | Gamma tipica | Cosa rivela |
|---|---|---|
| Contenuto di solidi | 35-45% | Mixing and reagent contact |
| Livelli di dosaggio | Low / mid / high | Economical dose |
| pH setpoints | Site-specific band | Finestra di stabilità |
| Tempi di campionamento | 2 / 6 / 12 / 24 h | Kinetics curve |
Il Triangolo d'Oro: tre prodotti, un fornitore
AuCyan™ Cianuro di sodio NaCN (≥98.3%) · AuCarb™ Recupero dell'oro Carbone attivo da guscio di cocco (durezza ≥99%) · AuLeach™ Agente di lisciviazione dell'oro (GDA) – Non pericoloso
3. pH control — the master variable
pH governs reagent stability, gold surface chemistry and the behaviour of interfering species. Establish a site-specific setpoint from bottle-roll work and hold it with automatic control. Drift outside the agreed band shows up first as slower extraction, then as higher consumption. In a Lisciviazione in vasca circuit, pH should be logged at the top, middle and bottom of each vat to detect stratification.
4. Split dosing and the knee of the curve
If the first half of the dose delivers 80% of extraction and the second half delivers 4%, the second half is not buying recovery — it is buying inventory. Split dosing with measurement lets you stop at the knee of the curve. On a 2,000 t/day Lisciviazione in vasca circuit, trimming an unproductive 0.15 kg/t saves around 300 kg/day, or roughly 110 t/year, with no change in gold output.
Unproductive dose: 0.15 kg/tonnellata
Daily saving at 2,000 t/day: 300 kg/giorno
Risparmio annuo: ≈ 110 t/year
5. Heap leaching versus Vat leaching commissioning
| step | Lisciviazione del cumulo | Lisciviazione in vasca |
|---|---|---|
| 1 — Caratterizzare | Column tests per ore domain | Bottle roll per ore domain |
| 2 — Set pH | Irrigation solution control | Vat solution control |
| 3 — Dose | Split across irrigation stages | Split across leach cycles |
| 4 — Recover | Carbon-in-Column from pregnant solution | Carbon-in-Pulp or solution wash |
Recovery of dissolved gold from the pregnant solution is a separate design step. AuCarb™ Gold Recovery Carbone attivo da guscio di cocco (durezza ≥99%) è usato in Carbonio in colonna service for clarified heap-leach solutions, selected on K and R values from the same test programme.
6. Consumption tracking
Log reagent consumption per tonne, per pad or per vat, and compare against the test-work band every shift. A divergence of more than 10% from the bottle-roll expectation should trigger a review of pH control, ore blending and dosing equipment before any additional reagent is ordered.
7. Supply and documentation
AuLeach™ GDA ships as a common chemical with a batch COA, TDS and MSDSin Sacchi in PE laminato per carichi pesanti da 25 kg. Il MOQ è 1 container da 20' ≈ 28 tonnellate per FOB / CIF termini. United Chemical serves more than 77 countries. Complimentary samples of AuLeach™ and AuCarb™ are available for independent laboratory testing before commercial supply.
8. FAQ
Q1 — Is this a non-cyanide system?
Yes. AuLeach™ GDA is a non-cyanide gold leaching agent supplied as a common chemical.
Q2 — Do I need to rebuild my circuit?
Typically no. The route is designed for existing Heap leaching and Vat leaching circuits, subject to test work.
Q3 — How is the reagent described for handling?
It is described as Non-Hazardous, with a batch COA, TDS and MSDS. No stronger characterisation is made.
Q4 — How do I choose the dose?
From a three-level bottle-roll programme, stopping at the knee of the extraction curve.
Q5 — What MOQ and terms apply?
1 container da 20' ≈ 28 tonnellate, FOB o CIF.
Q6 — Can the gold be recovered on Carbonio?
Yes. AuCarb™ carbon in Carbon-in-Column or Carbon-in-Pulp service is selected from the same test programme.
Commission a leach trial
Send ore grade, pH data and circuit configuration. We will return a bottle-roll protocol, a dosing curve and a landed-cost estimate.
Contattaci · Reagenti di lisciviazione · Panoramica dei tre prodotti · Domande frequenti sulla chimica · Industry News
WhatsApp +86 173 9270 5576 info@unitedchemicalcn.com
- Contenuto casuale
- Contenuti caldi
- Contenuto di recensioni hot
- Soda caustica Scaglie NaOH 96%-99% Idrossido di sodio
- Compressa giallastra per dosaggio di perossido di calcio al 60%
- Solfato di rame monoidrato (CuSO4-H2O) in polvere (Cu:34% min)
- Come posso valutare la fattibilità economica e l'efficacia dei prodotti chimici per l'industria mineraria?
- Acido ossalico anidro 99.6% grado industriale
- Acido etidronico | HEDP
- 1Cianuro di sodio scontato (CAS: 143-33-9) per l'attività mineraria - Alta qualità e prezzi competitivi
- 2Cianuro di sodio 98.3% CAS 143-33-9 NaCN agente di rivestimento dell'oro essenziale per le industrie chimiche minerarie
- 3Nuove normative cinesi sulle esportazioni di cianuro di sodio e linee guida per gli acquirenti internazionali
- 4Cianuro di sodio (CAS: 143-33-9) Certificato per l'utente finale (versione cinese e inglese)
- 5Codice internazionale di gestione del cianuro (cianuro di sodio) - Standard di accettazione delle miniere d'oro
- 6Fabbrica cinese Acido solforico 98%
- 7Acido ossalico anidro 99.6% grado industriale
- 1Cianuro di sodio 98.3% CAS 143-33-9 NaCN agente di rivestimento dell'oro essenziale per le industrie chimiche minerarie
- 2Elevata purezza · Prestazioni stabili · Recupero più elevato: cianuro di sodio per la moderna lisciviazione dell'oro
- 3United ChemicalIl team di ricerca di dimostra autorevolezza attraverso approfondimenti basati sui dati
- 4Cianuro di sodio ad alte prestazioni AuCyan™ | Purezza del 98.3% per l'estrazione globale dell'oro
- 5Detonatore elettronico digitale (tempo di ritardo 0~ 16000ms)
- 6Detonatore a tubo d'urto ad alta resistenza e alta precisione
- 7industria Detonatore elettrico




Consultazione messaggi online
Aggiungi un commento: